SpectraCal Panasonic BT-4LH310 - Manual

17544 Midvale Avenue N., Suite 100, Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com
Panasonic BT-4LH310
CalMAN Setup Guide
CalMAN Display Calibration Software can automatically create an optimized 3D calibration LUT for the
Panasonic 4LH310 monitor. Follow the procedure below to automatically create and load an optimized
3D LUT monitor calibration file into one of the Panasonic monitor’s three User operating modes.
Required CalMAN Software Version:

Version 5.4.0 or newer
Required CalMAN Workflow:

Color Cube (3D LUT)
Panasonic Monitor Software Version:

All versions work
Panasonic Monitor Control Connection:

Null modem 9-pin female to female serial cable

If a USB to serial adapter is required, the FTDI adapter (available from SpectraCal and online) is
recommended, as it includes a data buffer for superior data integrity at high communication
rates.
http://commercial.spectracal.com/store/accessories/calman-certified-usb-to-serial-
adapter.html
Panasonic Initial Setup
To calibrate the Panasonic monitor with a 3D LUT, you must manually configure desired settings
in the monitor before you switch the monitor to Remote mode in order to connect to the
monitor within CalMAN:
1. In the Panasonic Main Menu / System Config / Range menu:
a. Select “Full” for 0-1023 [10-bit] full range.
b. Select “Limited” for 64-940 [10-bit] SMPTE legal range.
2. In the Panasonic Main Menu / Control menu, select “Remote” to enable RS-232 remote
control.