SpectraCal Cine-tal DAVIO - Manual (Page 13)

V1.2 2013.04.23
With your normal video source signal connected to the Davio input and with a Davio output connected to your
monitor, select proper routing of the Davio 3D LUT to the monitor output. On the Davio Control Outputs tab:
1. Under Source, select the desired 3D LUT.
2. Under Color Space, select Full range. (The Davio Inputs and Outputs need to be set for Full range during
3D LUT calibration, even if you are calibrating for SMPTE range operation, and must be left in Full range,
even for operation in a SMPTE signal path.)
3. Under 1D LUT, select “Reset.”
DONE – Davio 3D LUT calibration and setup is complete.
Set Output Source to 3D LUT.
Set Color Space to Full.
Set 1D LUT to “Reset”