SpectraCal Lumagen Radiance User Manual
Page 3
3528 Bagley Ave. N. Seattle, WA 98103 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 |
Lumagen Radiance XD, XE, XS, Mini 3D, 20xx series, 21xx series
CalMAN Setup Guide
The Lumagen Radiance processors provide controls to calibrate 11 or 21 point grayscale. They also
provide controls to calibrate the standard CMS primary and secondary color points, or to calibrate a 3D
cube lookup table (LUT) for SMPTE video level signals. (NOTE: The Radiance models are not suitable for
creating a 3D LUT for use with full range/PC levels.)
Recommended CalMAN Workflows:
HT Advanced or SI Advanced to optimize panel or projector Picture controls.
HT Advanced or SI Advanced to calibrate Radiance grayscale RGB balance and standard CMS, or
Color Cube or CalMAN Studio to calibrate Radiance grayscale RGB balance and 3D LUT.
Required Radiance Firmware:
Any recent version for grayscale and standard CMS calibration.
091612, or later, for 3D LUT calibration
Radiance Control Connection:
21xx series: USB cable (serial cable can be used, at slower speed)
Older models: DB-9 female to DB-9 female null-modem RS-232 cable (pin2 - pin3, pin3 - pin2)
Radiance RS-232 Echo must be On
Menu > Other > I/O Setup > RS-232 Setup > Echo: On
Radiance Setup Process:
1. Connect the Radiance to the CalMAN computer with the specified cable.
2. A USB to Serial adapter, if used, needs to include a data buffer, such as the certified adapter
available on the SpectraCal web site.