SpectraCal Panasonic AX900 - Manual (Page 2)

17544 Midvale Avenue N., Suite 100, Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com
7. Under Network Status Details, note the Network Name to which the display is
connected and note the display’s IP Address.
8. Exit the display’s network setup.
9. Connect the CalMAN computer to the same wireless network to which the display is
connected.
CalMAN Connection Procedure
To connect CalMAN to the Panasonic display and enable the ISFccc mode:
1. On the Panasonic display, open the Picture menu.
a. Under Picture/Viewing Mode, select Professional 1 or Professional 2.
b. Under Picture/Lock Settings, select PIN.
c. Enter “
i085” (the ‘i’ button is just below the Power button on the remote).
d. Under Adjustment Lock, select Off.
e. Arrow down to isfccc Network and press OK on the remote.
f. At this point, the display will read “Waiting for Connection.”
2. In CalMAN, under “Find Display,” select “Panasonic – AS800, AX800, AX900
(Ethernet).”
a. Under Socket Connection, enter the IP Address you previously recorded.
b. Click Connect on the display connect panel.
3. In CalMAN, on the Display Control panel, under Display Mode Selection, select “Pro
1 - ISF Day” or “Pro 2 - ISF Night.”
Meter Mode (Target Display Type)
AX800 and AX900 series - The Panasonic AX800 and AX900 series displays have a very
wide color gamut, approaching that of the DCI/P3 specification. Select the ‘LCD (LED Blue
Green DCI/P3 Gamut)’ Meter Mode for the AX800 and AX900 series.
AS800 series - The Panasonic AS800 series displays have a more conventional LCD color
gamut. Select the ‘LCD (LED White)’ Meter Mode for the AS800 series.
Panasonic DDC Picture Controls:
Panasonic Picture controls are available within the CalMAN software, allowing you to make
display adjustments in the software, rather than using the display’s remote control. On those
calibration workflow steps where you need to make a manual display adjustment (e.g.
Brightness, Contrast, etc.), you can click the Open DDC Window button on the CalMAN
Display Control tab, then select Display Control to make those adjustments from the
CalMAN screen.
Panasonic Display Calibration:

Setup/Advanced (isfccc) – Select ON to enable the Professional modes.

Picture/Viewing Mode – Select PROFESSIONAL 1 or PROFESSIONAL 2.