SpectraCal CalMAN IR Controller User Manual
Page 2
17544 Midvale Ave. N. Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 |
3. Select your DVD reference disk on the CalMAN Source Settings tab
All the reference DVDs capable of automation are listed as “Infrared UIRT.”
(Note that not all reference DVD disks are suitable for automation, due to their
menu structure.)
4. Select your Player type
When you select a pattern source of type “Infrared UIRT”, a drop-down box
appears allowing you to select your DVD or BD player model. CalMAN has built-
in codes for the most common players.
If your player is not listed in the drop-down box, open the IR Code Editor in the
main CalMAN menu at the upper left. Using the IR Code Editor and your
remote control, you can teach CalMAN the control codes for your player.
5. Calibrate
When you start a CalMAN calibration session, CalMAN will prompt you to set the
calibration DVD to an initial state. Thereafter, CalMAN will automatically
select the correct pattern for the required task. If for any reason CalMAN and
the DVD player get out of step, use the Sync button (the top center button next
to the source device) to re-synchronize them.
Note: If you are using the AVS 1.2 DVDs, you will notice that CalMAN selects
Color HCFR patterns rather than CalMAN patterns. This is intentional. The
CalMAN patterns are designed to auto-advance and are therefore not good
targets for remote control.