SpectraCal CalMAN IR Controller - Manual

17544 Midvale Ave. N. Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com
CalMAN IR Controller
Quick-Start Guide
The CalMAN IR Controller is an Infra-Red transceiver
that sends the same commands to your DVD player
(or video processor) as a remote control.
CalMAN uses the IR Controller to automate
calibration. Rather than having to select
each pattern in a sequence manually,
you can push one button to perform the
whole sequence of readings, with CalMAN
advancing your DVD player or video processor
to the next pattern as needed.
1. Make sure that you have the most current CalMAN Device Driver Kit
If you have not downloaded and installed version 2.2 of the CalMAN Device
Driver Kit (required for the IR Controller), download it now from
Device Driver
Kit v2.2 . Run the MSI to install the Device Driver Kit on your system.
2. Install the CalMAN IR Controller Driver
Plug the IR Controller into a USB port on your computer. Windows will pop up a
Found New Hardware Wizard. At the prompt "What do you want the Wizard to
do," select the option, "Install from a list or specific location." Use the Browse
button to locate the directory where you installed the Device Driver Kit (by
default, c:\Program Files\SpectraCal\Drivers or c:\Program
Files(x86)\Spectracal\Drivers\USB-UIRT on Windows 64 bit computers)
Windows7 does not prompt for driver installation when a device is first
attached. To install the drivers, go to Start/Control Panel, choose System and
then choose Device Manager on the left hand side of the System Properties
window. Find your device in the list. Your device should be listed with a
yellow exclamation point on its icon. Right click on the device and choose
Update Driver Software. Choose Search my computer for driver software and
then continue following the directions for installing the driver as listed above.