Star Headlight & Lantern TDDL15-36-RRK Roof Rack Kit - Manual (Page 3)

-2-
Mounting
1. Determine how you wish to mount the
lights on the roof rack paying
particular attention to where you want
to run the harness to the switch (not
included).
2. Each undercover head should come
with two T-Bolts that will be used to
attach it to the roof rack.
3. Install one T-bolt through each slot in the L-
bracket as shown to the left. Loosely secure
the T-bolt with a flat washer, lock washer, and
a nut on each bolt. Repeat this for all of the
light heads.
4. Mount one of the brackets to the
rail of the roof rack by slightly
angling the T-bolts allowing them
to slip into the slot on the rail.
6. After all of the heads have been installed, make your final
adjustments positioning each head side-to-side and up and down
where you want them. Tighten all of the nuts, ensuring the T-bolts
remain rotated against the top and bottom of the roof rack channel.
5. Loosely hand tighten the nuts while slightly rotating each T-bolt
clockwise until it contacts the top and bottom of the groove,
helping secure it inside the groove. You may wish to use a
screwdriver or similar tool to help you rotate the T-bolts.
7. The angle of each individual light can be adjusted by loosening the
bolt securing it. Make your adjustments then tighten the bolt.