Star Headlight & Lantern TDDL15-36-RRK Roof Rack Kit - Manual (Page 6)

-5-
1. If you wish to change the synchronization pattern that the lights come pre-programmed
with, remove the plastic terminal block cover as described on page 3.
2. Disconnect the white wires on
each light you will be
programming.
3. For the DLX4 and DLX6, verify
that the Green/White wire from
each light is connected correctly
so your heads are in the desired
mode (Single or Split mode), as
described on page 3.
4. Program the pattern for the first light as described on pages 4.
5. Program the second light with the same Pattern Type, selecting the Phase based upon
the desired output (alternating or simultaneous).
6. Once you have found the desired pattern on the second light, re-cap the green wire to
prevent it from coming into contact with ground again.
7. Repeat Steps 1-6 above for each additional head you wish to synchronize.
8. Reconnect the white wires in the terminal block of the synchronized lights.
9. Replace the terminal block covers.
Synchronization
This harness has been pre-programmed at the factory so
that when properly mounted with the first pair of lights in the
rear of the vehicle, the next two pairs of lights at the front,
and the last pair of lights towards the rear, the four lights on
the right side of the vehicle are synchronized together and
the four lights on the left side of the vehicle are
synchronized together (see diagram to right).
We recommend using the factory default synchronization
settings. But if you wish to change the synchronization, please
review the section below and keep in mind the following:
• Only 6 lights can be synchronized. You cannot
synchronize all 8 lights.
• ALL SYNCHRONIZED LIGHTS MUST HAVE THE
SAME PATTERN TYPE !!!
• Lights that are programmed for the STEADY BURN
pattern will NOT be synchronized with any other lights.
• For lights running in Single Mode, Patterns 1-10 are in
Phase 1 and Patterns 11-20 are in Phase two.
• For lights running in Split Mode (DLX4/DLX6 only), Patterns 1-10 will flash side 1 in
Phase 1 and side 2 in Phase 2. Patterns 11-20 will flash side 1 in Phase 2, and side 2
in Phase 1.
• Lights or sides set for the SAME phase flash together (simultaneous), lights with
DIFFERENT phases flash opposite one another (alternate).
• Use the Pattern Shortcuts listed on page 4 to simplify programming.
(Optional Programming cont’d)