Star Headlight & Lantern TDDL15-36-RRK Roof Rack Kit - Manual (Page 4)

-3-
When wiring your lights, it is recommended that you take the following
precautions to reduce any Electromagnetic Interference (EMI).
• Keep LED modules and any radios as far away from each other as possible.
• Separate the radio wires and the LED wires:
• Any excess wires should be cut short.
External Wiring Connections
For ease of installation, there are only two wires in the main harness of the DLX*-RRK. If
the default flash pattern and synchronization settings are acceptable, these are the
only wires you need to connect.
Black: (Ground) – Connect the black wire to the negative side of your battery.
Red: (Power) – Connect the red wire to your switch supplying power.
+10-16VDC (DLX3 heads) +10-30VDC.(DLX4/DLX6 heads)
This lighting kit is designed such that there are several additional
options you can program including:
• Single or Split Flashing
• Flash Pattern
• Synchronization
If you wish to change any of these, you will need to gain access to
the terminal block located behind each head.
To do this, remove the two screws that secure the plastic terminal
block cover (see diagram to right).
Single or Split Flashing (DLX4 and DLX6 Only)
By default, the lights in the DLX4-RRK and
DLX6-RRK assemblies are wired for “Single”
mode (the whole head flashes at once).
Optionally you can wire them for “Split
Mode” (the pattern alternates back and forth
between the two halves of each light).
Green/White: (Split/Single Mode) – The Green/White wire controls whether your light
flashes in Single Mode or Split Mode. It is defaulted for Single Mode.
Single Mode: Connect with Black to Ground — Split Mode: Connect with Red to Power
Green: (Split Mode Steady Side Swap) – If you are in Split mode and select the Steady
pattern, only one side will be steady while the other will flash. If you want to swap
the Steady side to the other half of the light, hold the green wire to ground for 15
seconds until the light flashes 5 times, then release it.
Optional Programming