Star Headlight & Lantern 7400 Star Lase - Manual (Page 10)

-7-
LED Head programming consist of two options, Phase and Pattern:
Phase: Each light head in the Laser lightbar can be set for one of two phases. Two heads
that are set for the same phase will flash at the same time (simultaneous) and two
heads set for opposite phases will flash opposite of one another (alternating).
Pattern: Each LED head has 10 programmable patterns. If you have a pair of LED heads
that are both activated by the same color control wire (see page 4), they will be
programmed together. All LED heads that will be utilizing the same pattern should
be programmed together. Do so by activating all of the appropriate control wires
together, and then programming them.
Phase Selection
1. Remove the top extrusion from the lightbar as described on page 5, under the Wire
Harness Replacement section.
All LED heads installed at the factory will already be pre-programmed
with a default Flash Pattern and programmed for an appropriate Phase.
If the default flash pattern is acceptable, you can skip to the Takedown,
Worklight, or Traffic Director Head Programming section on the next page.
Optional LED Head Flash Programming
2. Each lighthead will be connected to the
“T” shaped communications board inside
the lightbar.
Please note that all 20 connectors
will be used only in the 58” lightbars.
For 52” bars, connectors 4 and 14
will be empty. For 46” bars, connectors
4, 5, 13, and 14 will be empty. For 34” bars,
connectors 3, 4, 5, 6, 12, 13, 14, and 15 will be empty.
3. Above each connector you will find the Phase Jumper. All of the heads that have the
jumpers on the left two pins will flash on and off at the same time (if their control wires
are activated). All of the heads with the jumpers on the right two pins will also flash
together with one another, but they will also be flashing opposite the heads with the
jumper on the left two pins.