Star Headlight & Lantern 7400 Star Lase - Manual (Page 12)

-9-
GREEN w/YELLOW: Illuminates all of the front facing heads that have Takedown mode
activated into a steady-burn mode.
GREEN w/WHITE: Illuminates all of the rear facing heads that have Takedown mode
activated into a steady-burn mode.
1. Apply +12VDC to all of the appropriate control wires for each front location (see page 4).
All of the corresponding lights should start flashing.
2. With the heads still flashing from Step 1, also connect the GREEN w/YELLOW Front
Takedown wire to +12VDC.
• Any lights that illuminate in a steady-burn mode are already programmed to act
as takedowns.
• Lights which continue flashing are NOT programmed for Takedown Mode.
3. Note which heads are already programmed for Takedown Mode and which are not, then
disconnect the front control wires.
4. To program any flashing front heads for Takedown Mode or remove the Takedown
Mode from any heads, leave the GREEN w/YELLOW wire connected to power and
activate the heads you wish to change by connecting the appropriate control wire(s) (see
page 4) to +12VDC.
5. Briefly touch the RED w/GREEN stripe wire to +12VDC and release it.
• The heads that were flashing should now be lit in a steady-burn mode. This
indicates that they are now programmed to activate as Takedowns whenever
power is applied to the GREEN w/YELLOW stripe wire.
• The heads that WERE NOT flashing should now be flashing, and are no longer
in Takedown Mode.
6. Once you completed the programming, disconnect the control wires and the GREEN w/
YELLOW wire to turn the light off.
7. To add or remove Takedown mode for any of the rear heads, repeat steps 1-6, using the
GREEN w/WHITE wire, instead of the GREEN w/YELLOW wire.
8. Once your programming is complete, tape the end of the RED w/GREEN stripe wire so
that it does not come into contact with +12VDC.
NOTE: Before programming any heads for Takedown mode, examine the wires
from the power harness and be sure the RED wire is connected to constant
+12VDC, and the BLACK wire is connected to the negative side of the battery.
Takedown Mode Programming Summary
RED - +12VDC
BLACK - Battery Negative (-)
GREEN w/YELLOW -(Front)
or
GREEN w/WHITE -(Rear)
• Activate the heads you want to program with
+12VDC to Proper Control Wire (see page 4)
• Use RED w/GREEN to +12VDC to program.
+12VDC
}
(Takedown and Worklight Programming CONT’D)