Star Headlight & Lantern 7400 Star Lase - Manual (Page 14)

-11-
(TRAFFIC DIRECTOR SETUP CONT’D)
Traffic Director Wiring and Programming
Internal Traffic Director Controller Wiring
If you will be using an external controller (such as the TD77-2) to operate your traffic
director, skip to the External Traffic Director Controller Wiring section on page 13.
• Use of the internal (built-in) controller will require three (3) standard On/Off switches
(user supplied). The three switches will individually operate the Warn, Right, and
Left Patterns. Activating the Right and Left patterns both at the same time will
produce a Center-Out Pattern.
• The traffic director functions will be activated by applying +12VDC to the appropriate
wires.
• Only 6 of the wires from the Traffic Director Harness will be used. Connect them as
described below.
BROWN (Activates WARN Pattern)
YELLOW (Activates LEFT Arrow)
GREEN (Activates RIGHT Arrow)
(Center-Out pattern displayed by
Activating RIGHT and LEFT at the
same time - GREEN+YELLOW)
Silver CABLE SHIELDING (RFI Reduction) - Connect to the negative terminal of
your battery (provides shielding and
grounding).
LARGE RED (Power) - Connect to constant +12VDC.
PURPLE (Programming) - ONLY used during Programming.
Touch and release to +12VDC to
program Number of Heads and
Pattern Style (described on the
following page).
}
These three wires should each be
connected to +12VDC through three
separate switches (user provided).
Note: Connect all of the necessary wires from your standard lightbar
harness PRIOR to connecting the traffic director harness.