Star Headlight & Lantern ULB48 Lineum Dual-Color Traffic Director Interior LED Lightbar - Manual (Page 6)

-5-
Because of the wide variety of mounting applications, Star Headlight
& Lantern Co., Inc. assumes no responsibility for the secure mounting
of this light. It is the responsibility of the installer and/or owner to
ensure the lightbar is mounted securely. Check your light every time
you enter the vehicle to ensure that it is mounted securely.
5. Adjust the mounting brackets so that they rest flat against the corner post on each side
of the vehicle.
6. Once the brackets are adjusted to the desired position, tighten all the screws on the
brackets.
7. Mark the two spots where you will be attaching your screws to the corner post.
8. Loosen the brackets, temporarily slide them aside, and drill a 1/8" hole in each of the
marked locations.
Caution: Be sure to check that there are no wires or anything else behind the molding
that may be damaged by the screw holes.
9. Return the brackets to their original position against the corner post and use two of the
self-tapping screws in each side to secure each bracket to the corner posts.
10. Once the brackets are securely tightened, check your mount to ensure the desired angle
is achieved. Stand behind the vehicle and inspect the light through the rear window.
The screws may be loosened slightly to allow for any final adjustments necessary.
11. Once all the necessary adjustments are made retighten all the screws.
CAUTION: Take extreme caution not to over tighten the screws!!! Over tightening
of the screws can strip the holes and result in a faulty mount.
Corner Post Bracket Installation (CONT'D)