Programming – Star Headlight & Lantern ULB48 Lineum Dual-Color Traffic Director Interior LED Lightbar User Manual
Page 8
-7-
Programming
Programming is optional. If the default settings
are acceptable, skip to the Operation section.
If you will be changing any of the options on your lightbar, this should be done prior to
installation. Programmable features include the following:
• Traffic Director or Takedown Mode
• Dim Option (High-Low)
• Pattern Selection
• Phase Selection (which heads alternate)
• Head Enable (which heads activate)
• Title 13 Programming
• Pattern Cycling
• Resetting the Factory defaults
• Program Mode (Copying all settings from one light to another)
Traffic Director /Takedown
This light has the option to operate in either Traffic Director Mode or Takedown Mode.
By default, standard ULB48-TD lightbars will be shipped with Traffic Director Mode ON
(DOWN in the picture above).
If you will NOT be using the Traffic Director functions of this bar (Warn, Left, Right, and
Center Out) you can move this DIP switch into Takedown Mode (UP) which will replace the
Traffic Director Functions with Pursuit, Takedown, and Title 13 functions.
There are three DIP
switches, two push-button
switches, and a telephone-
style jack, all located on the
top of the light, that should
be used to set any of these
options prior to
installation.
Please Note: A small black
adhesive-backed plastic
plate (P30019-148 ) is
included to cover the
opening once all
programming has been
completed.
ON
CTS
1
2
3
P
ro
g
ra
m
M
o
d
e
H
ig
h
-L
o
w
/P
a
tt
e
rn
T
ra
ff
ic
D
ir
e
c
to
r/
T
a
k
e
d
o
w
n
P
h
a
s
e
P
ro
g
ra
m
m
in
g
H
e
a
d
E
n
a
b
le
P
ro
g
ra
m
m
in
g
Communication Port
High-Low/Pattern Option
This light is equipped with an option allowing you to dim the light for nighttime operation. If
you do not need this feature, skip this section.
The High-Low/Pattern Option switch is used to control the function of the Green w/Red wire.
The Green w/Red wire is normally used for Pattern Programming (see next page). If you
are using the Dim feature, AFTER PROGRAMMING YOUR FLASH PATTERNS, flip this
switch into the ON position (DOWN in the diagram above). When +12VDC is applied to the
Green w/Red wire, the light will dim.