Directed Electronics 3000ESP - Manual (Page 10)

6
© 1999 Directed Electronics, Inc.
Using Your System
Pressing for one second will arm the system and lock the
doors. The red LED will begin to flash once per second. The
Failsafe® Starter Kill will prevent the vehicle’s starter from crank-
ing if it has been installed. If connected, the vehicle's horn will
honk and the parking lights will flash once to confirm arming of
the system. If the ignition is turned on while the system is armed
the horn will honk and the parking lights will flash (if connected).
NOTE: You must use your remote transmitter to lock the vehicle in order
for the system to be armed. Manually locking the vehicle does not arm
the system; it will only lock the doors. If you have not used the remote
transmitter to lock the vehicle doors (i.e. the vehicle has been locked using
the lock/unlock switch) the transmitter cannot be used to unlock the doors.
The system also can be programmed to arm the starter kill auto-
matically (called passive mode). If the system is programmed for
passive mode, it will automatically activate the starter kill 30 sec-
onds after the ignition is turned off. Passive mode is indicated by
rapid flashing of the LED after the ignition is turned off.
NOTE: For passive mode to be effective, the Failsafe® Starter Kill relay
must be installed.
If passive mode is programmed on, it is also possible to program
the system to lock the doors automatically. This is called passive
locking. If passive locking is turned on, care must be taken to pre-
vent the keys from being locked in the vehicle.
Arming/Locking