Directed Electronics 3000ESP - Manual (Page 12)

8
© 1999 Directed Electronics, Inc.
Use the Silent Mode to temporarily turn off the arm or disarm con-
firmation honks by briefly pressing before either arming or
disarming the system. The confirmation honk(s) will then be elim-
inated for that one operation only. To permanently turn off the
arm and disarm confirmation honks, contact your installation
dealer.
You can prevent your system from automatically activating the
Failsafe® Starter Kill relay and locking the doors, by using Valet®
Mode. This is very useful when washing the vehicle or having it
serviced. In Valet® Mode, the system will not activate the Starter
Kill, even with the transmitter, but all convenience functions
(door locks, trunk release, etc.) will work normally.
To enter or exit Valet ® Mode with the Valet switch
Turn ignition to “on” position,
then turn to “off” position. Press
and release the Valet switch within
10 seconds. The status LED will
light steady if you have entered
Valet Mode. To exit Valet Mode,
repeat the steps above. The LED
will turn off when exiting Valet
Mode.
DRW-35
Valet® Mode
Silent Mode