SurgeX SX-AX20 - Manual (Page 26)

SX-AX15 (20) User Manual
Page 25
VII. Advanced Operation
(continued)
Timed Events
The Axess provides the ability to turn On, Off, or Cycle outlets based on time and date. Each
individual outlet or group can be set to operate a selected command at a specific time and date.
The Timed Events are programmed through the Setup & Control Utility or the CLI interface. Up
to 16 events can be created.
Each event can be assigned to one outlet or group and repeated on a regular basis.
Administrative rights are required to set up and manage any event. To add an event, create the
event, assign the event to a specific outlet or group, and then configure the initial occurrence of
the event, the action to be performed, and the repeat frequency, if desired.
To configure the timed events, use the following commands:
get events
get event <eventname>
add event <eventname>
dev event <eventname>
ren event <eventname> <new name>
set event <eventname> year <2007 – 2050>
set event < eventname> month <1
‐12>
set event <eventname> day <1
‐31>
set event <eventname> hour <0
‐23>
set event <eventname> minute <0
‐59>
set event <eventname> action <on | off | cycle>
set event <eventname > repeat < never | daily | weekly | monthly | annually>
set event <eventname> control outlet <1
‐8>
set event <eventname> control device <#1
‐#16 | devname> outlet <1‐8>
set event <eventname> control group <groupname>