Ubiquiti Networks airFibe5 - Manual (Page 19)

17
Hardware Installation
6. Attach the Azimuth Support Brackets together.
a. Insert the two M10x100 Carriage Bolts into the Azimuth
Support Bracket that has two slotted holes.
b. Slide the slotted hole of the other Azimuth Support Bracket
over one M10x100 Carriage Bolt.
c. Place one M10 Serrated Flange Nut on each M10x100
Carriage Bolt.
7. Check the four Pre-Installed M10x25 Flanged Bolts to ensure that
there is a 13 mm gap between each bolt head and its trunnion.
13 mm 13 mm