Ubiquiti Networks airFibe5X - Manual (Page 20)

16
Chapter 1: Wireless Tab airFiber ® AF-5X User Guide
Ubiquiti Networks, Inc.
Chapter 1: Wireless Tab
The Wireless tab contains options to set up the wireless
part of the link. This includes wireless mode, link name,
frequencies, output power, speed, and wireless security.
Change To save or test your changes, click Change.
A new message appears. You have three options:
•
Apply To immediately save your changes, click Apply.
• Test To try the changes without saving them, click
Test. To keep the changes, click Apply. If you do not
click Apply within 180 seconds (the countdown is
displayed), the AF-5X times out and resumes its earlier
configuration.
• Discard To cancel your changes, click Discard.
Write down the settings you configure on the Wireless
tab. You will need to enter the same settings on the AF-5X
at the other end of your PtP link. The exceptions are as
follows:
•
Wireless Mode Configure one AF-5X as the Master and
the other as the Slave.
Basic Wireless Settings
In this section, configure the basic wireless settings, such
as wireless mode, link name, country code, frequencies,
output power, speed, and gain.
Wireless Mode By default, the Wireless Mode is Slave. You
must configure one AF-5X as Master because each PtP
link must have one Master.
Link Name Enter a name for your PtP link. This name
must be the same on both Master and Slave radios in
order for them to connect.
Country Code Each country has its own power level and
frequency regulations. To ensure the AF‑5X operates under
the necessary regulatory compliance rules, you must select
the country where your device will be used. The frequency
settings and output power limits will be tuned according
to the regulations of the selected country. For details, refer
to this table, “Frequency Ranges and Power Levels per
Country/Region” on page 41.
This radio is restricted to use with a license and to use only in
certain EU countries or geographical areas of EU countries.