Ubiquiti Networks airFibe5X - Manual (Page 9)

5
Chapter 1: Installation airFiber ® AF-5X User Guide
Ubiquiti Networks, Inc.
10. Configure the Wireless Security:
a. Select the AES Key Type, HEX or ASCII.
b. For the Key field:
- HEX Enter 16 bytes (eight, 16‑bit HEX values: 0‑9, A‑F,
or a‑f). You can omit zeroes and use colons, similar to
the IPv6 format.
Note: The airFiber Configuration Interface
supports IPv6 formats excluding dotted quad
and "::" (double-colon) notation.
- ASCII Enter a combination of alphanumeric
characters (0‑9, A‑Z, or a‑z).
11. Click Change and then click Apply.
12. In-Band Management is enabled by default, so each
airFiber radio must have a unique IP Address. (If the
airFiber radios use the same IP Address, you may lose
access to the airFiber radios via the DATA ports.) Click
the Network tab.
a. For the Management IP Address option:
- DHCP Keep the default, DHCP, to use DHCP
reservation on your router to assign a unique IP
Address.
- Static Change the IP Address, Netmask, and other
settings to make them compatible with your network.
b. Click Change and then click Apply.
Repeat the instructions in the airFiber Configuration
section on your other AF-5X. After you have configured
the airFiber radios, disconnect them and move them to
your installation site.
Hardware Installation
Install a Ground Wire
1. Remove the nut from the Ground Bonding Point located
on the back of the AF-5X.
Ground
Bonding
Point
2. Attach a ground wire (min. 10 AWG or 5 mm 2 ) to the
lug and replace the nut to secure the wire.
3. At the installation site, secure the other end of the
ground wire to a grounded mast, pole, tower, or
grounding bar.
WARNING: Failure to properly ground your
airFiber radio will void your warranty.
Note: The ground wire should be as short as
possible and no longer than one meter in
length.