UVP 81-0357-01 PCR Hoods - Manual (Page 10)

PCR Workstations and Cabinets Page 10
Door Assembly
1. Remove the protective film from the Makrolon
®
panels.
2. Slide the upper panel of the Door Assembly into slotted area in the Top Assembly. Holding the door
in position, use the black thumb screws (qty. 3) to attach the upper door panel to the Top
Assembly. NOTE: To help the screw holes align, slide the Door Assembly fully up into the Top
Assembly, then slightly lower the Door Assembly.
3. Ensure that the Side Panels are pushed as far back into the Back Panel as possible. Then, secure
the upper panel of the Door Assembly to the left and right side panels with the two side brackets. If
the brackets and holes don’t align, it may help to push up on the bottom of the Door Assembly until
the holes align. NOTE: The brackets are side-specific, meaning that each bracket will only fit on
one side of the panels.
4. A magnet is attached to the bottom right bracket on the door. The purpose of the magnet is to shut
off the overhead UV light when the door is open.
Note: Some systems may have a single large bracket running along the width of the entire lower
door, rather than the two small brackets shown below.
When the PCR Hood is assembled, plug the power cord into the back of the unit and then into a wall outlet
in the laboratory.
WARNING: The PCR Hood is for laboratory use and cannot be connected to a public power supply.
Thumb Knobs
Door Assembly
Side Brackets
Magnet
Top Assembly
Door Hinges
Door Brackets