UVP 81-0357-01 PCR Hoods - Manual (Page 14)

PCR Workstations and Cabinets Page 14
Care and Cleaning
The PCR Hoods are built to provide trouble-free operation.
NOTE: The door and side panels are made of Makrolon ® and are subject to scuffing and scratches if
improperly cleaned.
NOTE: Crazing is a normal process for Makrolon
®
panels exposed to UV light. Crazing will occur
over a period of time. Reduce crazing by keeping UV exposure to a minimum. Crazing may occur
within the warranty period and is regarded as normal wear which is not covered by the warranty. If
crazing of the Makrolon
® panel occurs, the panel can be replaced. Refer to Replacement Parts for
part numbers.
The stainless steel and aluminum surfaces are manufactured with an antimicrobial coating to reduce
bacterial growth. Care in cleaning and use of the equipment is recommended to reduce wear of the
coating. To clean the unit:
•
Wipe excess water from inside the unit and outside the unit with an absorbent soft cloth or
sponge.
•
Use mild soap and a damp, soft cloth or damp sponge to clean the exterior of the unit.
•
Use a mild detergent on the interior surfaces.
•
Warning: Unplug the unit before cleaning around the UV tube contacts and internal plug
outlets.
•
Clean the Makrolon
®
panels with a mild detergent; never use organic-based compounds or
cleaners containing alcohol or ammonia.
•
Surface decontaminants such as RNase AWAY ® (used to eliminate RNase and DNA from
laboratory surfaces) and DNA AWAY™ (used to remove DNase and DNA contamination) are
safe to use on PCR Hood panels.
•
For general cleaning of the Makrolon
®
panels, a plastic cleaner solution is recommended and
is available from local plastic supply distributors.
•
Do not use abrasive pads or cleansers.