Velodyne SC-602 Amplifier - Manual (Page 12)

www.velodyne.com 6 - SC-602 Amplifier User’s Manual
(11) IR Input
An IR repeater can be connected to this mini-jack.
(12) 12V Trigger
When this 2-conductor mini-jack is connected, the amplifier remains in power-off mode untilthe trigger
is applied. The correct trigger is +12V on the tip of the connector relative to thegrounded sleeve.
(13) RS-232 In
Use this port to communicate with an RS-232 controlled touch panel system. See AppendixA for an
explanation of the use of the serial port, available commands, and their formats.(14) Signal Sensing Auto
On/Off SwitchWith this switch in the “standby” position, your subwoofer can be safely left with the main
power switched on continuously. The subwoofer amplifier will turn itself on automatically whenan audio
signal is present. If no signal is present for approximately 10 minutes, the unit willswitch to standby
mode. While in standby mode, your subwoofer amplifier will draw veryminimal power. This function can
be disabled by leaving the switch in the “always on” position.
(15) Speaker Level Input Terminals
If you do not connect the SC-602 amplifier to your receiver using the line input/LFE inputconnection
(Item 10), connect these input terminals to the speaker output terminals of youramplifier or receiver. If
you use this method of connection, make sure to select the “large”speaker option in the receiver’s set-
up menu. Also, select the option for no subwoofer. Thiswill make sure all bass and lFe information is fed
the speaker outputs and be received byyour SC-602 amplifier.
Note: Using both speaker terminals and the line level inputs is not recommended, as this maydamage the SC-
600D amplifier or your receiver.
(16) Speaker Level Output Terminals
These connections send a crossed-over speaker-level signal to the front speakers. Whenconnected
in this fashion, your satellite speakers will be crossed over at 80 Hz. This removes the lower bass
frequencies from your satellites, enabling them to do a better job reproducing high frequencies.
You may also connect your satellites directly to your receiver or amplifier along with the subwoofer if you
wish to bypass this crossover.
An example of a speaker-level connection is shown in Figure 3.