Velodyne SC-602 Amplifier - Manual (Page 13)

www.velodyne.com SC-602 Amplifier User’s Manual - 7
Figure 3: Speaker-Level Connection.
(17) and (18) Subwoofer Connection 5-Way Binding Post Terminals
Connect the output terminals to the subwoofer being controlled by the SC-602 amplifier. Only connect
one subwoofer to the red/black pair of subwoofer output terminals - do noT connect multiple
subwoofers to the terminals in any configuration.
Caution!!!
To avoid damage to your SC-602 amp and subwoofer, be sure to maintain correct polarity when making all
speaker connections; red (positive) to red, and black (negative) to black. Be sure that all connections are tight,
and that there are no loose strands or frayed wires.
(19) Power Cord Adapter
Connect the detachable power plug to this male interface connection. The detachable cord allows for
easy replacement should the original become damaged.
(20) Main Power Switch
Press the POWER switch to the ON position to activate the amplifier. If the unit is to be left unused for
an extended period of time, move this switch to the OFF position to prolong the life of the amplifier.
(21) Fuse
If the unit is not functioning, check the fuse. If the fuse is blown, replace with an identically rated fuse. If
the fuse blows again, refer the unit for service.