Voodoo Lab System Mix Plus - Manual (Page 15)

14
D I G I T A L M U S I C C O R P O R A T I O N
3. The stereo outputs of the effects
are brought back to the mixer to be
blended with the original preamp tone
using In 2 and In 3 of Mix 2. Mix 2 In
1 is being used by the internal
connection with Mix 1 (the preamp).
Next, the Mix 2 Outputs are connected
to the power amp input, or the amp
effect return.
4.
Additionally, you can connect
the rear panel Direct Outs or the front
panel Balanced Outs to a mixing console
or recorder. Be sure the Cabinet
Simulator is on.
In this example, the Mix 1 knob controls the level of the preamp, and the Mix 2 knob controls the
level of the entire mix. Please refer to Section 3.3 to correctly set levels.
System #2 + GCX Loops
This example uses six loops to switch the inputs of the effects. It is important to note that
although FX 1 and 2 are stereo, they begin with a mono signal and therefore need only one loop
each to switch them. FX 3 and 4 are shown using two loops each for switching.
1. The guitar is connected to the amp or
preamp input. The preamp output or amp
effect send is connected to the Left volume
control input.
2. The signal comes out
of the volume control and is
fed into Mix 1 In 1 Left. The
passive split sends copies of
the preamp signal to the inputs
of two different GCX loops
instead of going directly to the
inputs of the effects devices.
Next, the send of each GCX
loop is connected to effect
inputs. When the loops are on, the signals pass through. When the loops are off, the sends to the
effects are muted.