Voodoo Lab System Mix Plus - Manual (Page 5)

4
D I G I T A L M U S I C C O R P O R A T I O N
10. MONITOR Ground Lift: Disconnects the sleeve of the MONITOR IN jack from ground
with the button pushed in.
11. MONITOR Phase Invert: With the button pushed in, the phase of the MONITOR IN signal
is inverted.
12. HEADPHONE LEVEL Direct: Adjusts the headphone volume of your mixer signal.
13. HEADPHONE LEVEL Monitor: Adjusts the headphone volume of the MONITOR IN
signal.
14. MONITOR IN: Accepts a stereo (TRS) plug for headphone monitoring of external signals
(monitor mixes, etc.)
15. HEADPHONE: Stereo headphone output. The impedance of the headphones should be 30
Ω or greater.
16. FEED THRU 1-4: These four separate, passive mono feeds connect directly to the four
FEED THRUs on the rear panel.
2.2 Rear Panel
[Note: All of the 1/4 inch jacks on the rear panel are for mono plugs. Except for the four FEED
THRUs, the top row is for the Left channel of your stereo signal and the bottom is for the Right.
Any mono signals should be plugged into the Left inputs (except for Mix 2 In 1). They will
automatically feed both the Left and Right channels.]
1. POWER: Requires 9 VAC at 1.0 amp.
2. MIDI
FEED: Direct passive feed thru to the MIDI FEED on the front panel.
3. MIDI
IN: Standard 5 pin MIDI connector. Accepts commands for MIDI controlled volume,
and passes all data to the MIDI THRU jack.
4. MIDI
THRU: Standard 5 pin MIDI connector. Outputs all MIDI data that comes in through
the MIDI IN jack.
5. Passive
Split: These outputs carry the same signals coming in the "Mix 1 In 1" inputs.
Enables you to feed these signals somewhere else without having to use Y-cables.
6. Mix 1 Inputs: Four stereo, line level inputs to Mix 1.
7. Mix 1 Out: Two identical sets of Left and Right line level outputs from Mix 1.