Voodoo Lab System Mix Plus - Manual (Page 16)

15
D I G I T A L M U S I C C O R P O R A T I O N
3. The stereo outputs of the effects are brought back to the mixer
to be blended with the original preamp tone. For FX 1 and 2, we
will use In 2 and In 3 of Mix 1. These effects will be blended in
parallel with the original preamp tone.
4. Next, the two stereo Mix 1 Outs are used to drive four different GCX loops (Left and Right for
two devices). The sends of the loops are connected to the appropriate inputs on FX 3 and 4,
allowing them to be muted by the GCX. The Mix 1 signal is sent to Mix 2 via the internal
connection and the stereo outputs of FX 3 and 4 are brought back to the mixer (In 2 and In 3
of Mix 2) to be blended with it.
5.
Mix 2 Outs are connected to the power amp input or the
amp effect return.
6. Additionally, you can connect the
rear panel Direct Outs, or the front panel
Balanced Outs to a mixing console or
recorder. Be sure the Cabinet Simulator
is on.
In this example, the Mix 1 knob controls the level of the preamp and FX 1 and 2. The Mix 2
knob controls the level of the entire mix. Please refer to Section 3.3 to correctly set levels.