Vortech 2004-2006 Ford 5.4L 3V F-150 - Manual (Page 15)

7
P/N: 4FN020-010
©2007 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
02MAR07 v2.0 Ford F-150(4FNv2.0)
Fig. 6-c
G. Install the supplied power steering reservoir
mounting bracket onto the supercharger
mounting bracket using the two 5/16" x 3/4"
bolts. Attach the reservoir to the bracket
using the original 6mm screws and the sup-
plied nuts. (See Fig. 6-c.)
H. Remove the cap from the supercharger oil
feed and using engine oil on the threads,
install the 1/8"NPT x -4 x 90° fitting so that it
points down. Attach the free end of the oil
feed line to the fitting and tighten. (If the oil
feed hose does not reach, loosen the 90°
end of the oil feed hose and re-position.)
I. Attach the capacitor removed from the top
of the engine cover to the 8mm hole in the
supercharger mounting plate using the
remaining power steering reservoir hold-
down screw.
J. Verify that the accessory drive belt has
clearance to all hoses and wires.
NOTE: DO NOT use any type of sealant on the oil
feed fittings. It may become dislodged and
clog the oil feed orifice, causing premature
failure of the supercharger.
NOTE: If the belt does not have enough slack to
allow installation, start the belt around the
supercharger and have an assistant rotate
the engine (with a ratchet on the harmonic
damper bolt) until the belt is completely
installed.
6. SUPERCHARGER INSTALLATION, cont’d