Vortech 2004-2006 Ford 5.4L 3V F-150 - Manual (Page 9)

1
P/N: 4FN020-010
©2007 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
02MAR07 v2.0 Ford F-150(4FNv2.0)
A. Disconnect negative cable at the battery.
B. Remove the valve cover breather hose from
the passenger side side valve cover to the
air filter housing.
C. Remove all ducting up to but not including
the throttle body.
D. Remove the Mass Air Flow (MAF) sensor
and Torx screws from the factory air inlet
duct and set aside.
E. Remove the accessory drive belt.
F. Remove the plastic core support cover (on
top of radiator and hood latch area) and set
aside.
G. Remove the power steering reservoir sup-
port bracket. Set aside the three reservoir
hold down screws for later use.
H. Remove the nut securing the capacitor and
the two bolts from the front engine cover.
(See Fig. 1-a.).
I. Remove the hose that runs from the driver’s
side valve cover to the intake.
1. COMPONENT REMOVAL AND PREPARATION
FACTORY FASTENERS
REMOVED FROM THESE
TWO LOCATIONS
THREADED BOSS WILL BE
USED IN SECTION 5 TO MOUNT
SUPERCHARGER PLATE
Fig. 1-a