Vortech 2004-2006 Ford 5.4L 3V F-150 - Manual (Page 20)

12
P/N: 4FN020-010
©2007 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
02MAR07 v2.0 Ford F-150(4FNv2.0)
IMPORTANT: To ensure trouble-free programming of
your vehicle’s computer:
• Make sure the vehicle’s battery is sufficiently
charged.
• Turn off all accessories and close doors to
prevent unecessary drain on battery.
• Do not attempt to program your vehicle while
a battery charger is connected.
• Improper battery voltage will result in failure
of the programming process.
• Do not disconnect the cable or turn off the
ignition during programming.
A. Re-connect the battery.
B. Locate the vehicles OBD2 connector locat-
ed in the lower right hand corner of the
dash on the driver’s side of the vehicle.
C. Attach the OBD2 connector from the Flash
tool that is provided in the kit to the vehicle’s
OBD2 port.
D. The Re-flash tool will power up and display
three parameters.
1.
Performance Tune
2. Diagnostics
3. Options
E. Select “Performance Tune” and press the
enter button in the middle of the arrow keys.
F. Read the disclaimer entirely, then select
agree and press ENTER.
G. At this point, please read the screen dis-
played on the re-flash tool. If you have any
questions, either refer to the manual that is
provided with the re-flash tool or contact our
service department for further assistance.
H. Turn the ignition on (do not start the vehi-
cle). Set the parking brake and press the
ENTER button to continue.
I. SELECT TUNE will be displayed at the top
of the screen. Use the arrow keys to select
the appropriate tune for your vehicle and
press the ENTER button. You will have a
choice of three to choose from:
1.
Supercharged F-150
2. Original Backup
J. Continue to follow the screen commands
and, when finished, unplug the re-flash tool
from the vehicle’s OBD2 port.
9. RE-FLASH COMPUTER
NOTE: Do not disturb the cable or turn the ignition
off during this time. If the programming is
disrupted, the computer will not start or
run your vehicle!