Radiator reservoir relocation, Power steering plumbing – Vortech 1999-2000 Honda Civic Si User Manual
Page 14
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
6
7.
RADIATOR RESERVOIR RELOCATION
A. Remove the rear most top and bottom bolts from
the bracket holding the electrical plugs on the pas-
senger side strut tower.
B. Position the supplied bracket per Fig. 7-a and reinstall
the hardware.
C. Fit the reservoir to the bracket with the cap in-
stalled.
D. Run the supplied 5/16” hose from the radiator fill
neck to the radiator reservoir cap.
E. Remove the factory vent tube/water line assembly
from the valve cover breather. This assembly will
no longer be used.
F. Replace the hose running from the bottom of the
throttle body to the engine block with a piece of
the supplied 5/16” hose. Secure with the factory
clamps.
8. POWER STEERING PLUMbING
Fig. 7-a
Passenger strut tower as viewed
from the driver’s side of the vehicle
A. Lightly coat the O-ring on the supplied power steer-
ing pump fitting with Honda power steering fluid
and insert into the power steering pump. Rotate
fitting until the bolt holes line up with the pump.
Secure the fitting to the power steering pump using
the supplied 6mm bolts and washers.
B. Attach the straight fitting end of the supplied power
steering hose to the just installed power steering
pump fitting and tighten.
Fig. 8-a