Vortech 1999-2000 Honda Civic Si - Manual (Page 26)

P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
17. FINAL CHECK
A. Reinstall the headlight, front bumper and splash
guard removed in step 1.
B. Reconnect battery.
C. Make sure that all oil drain and oil feed fittings are
connected and tight and that the engine is filled
with factory specified oil.
D. Make sure that the radiator and reservoir are full.
E. Verify that the power steering reservoir is at “full
cold” level.
F. Insert the supplied 20 amp fuse(s) into the fuel and af-
tercooler water pump fuse holder if so equipped.
G. While listening to area near auxiliary fuel pump, key
ignition on and verify fuel pump operation. Fuel
pump should operate for a short time and then turn
off. Cycle the fuel pump several times by turning
ignition on and then off. Check all fuel system hose
connections for leakage.
18
16. POWER STEERING PLUMbING/bLEEDING
Fig. 16-b
Fig. 16-a
Caution: The Honda Shop Manual recom-
mends using only Honda Power
Steering Fluid -V or S as any other
fluid can cause poor performance
and increased wear.
A. Install the supplied power steering belt in the stock
location.
B. Loosely attach the power steering pressure hose
to the remaining power steering fitting. With the
original O-ring installed (replacement supplied) slide
the original power steering fitting into the other end
of the fitting.
C. Install the fitting in the receiver in the mounting
bracket top plate. Secure using the supplied 1/4-20
cap screws (see Fig. 16-a). Rotate the 90° fitting for
the best hose routing and tighten fitting (see Fig.
16-b).
D. Reattach the factory power steering return hose to
the power steering pump with the original clamp.
E. Fill the power steering reservoir to the upper level
line. bleed the system by starting the engine and
running it at a fast idle while turning the steering
wheel lock to lock several times. Recheck the fluid
level.