Vortech 1999-2000 Honda Civic Si - Manual (Page 15)

P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
P/N: 4HC020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19JAN04 99-00Honda Civic Si(4HC v3.0)
A. Remove the top four transmission-to-bell housing
bolts and the bracket that the ground strap is at-
tached to.
B. Remove the bracket and grommet securing the top
of the radiator to the vehicle. Install the supplied
bracket and original grommet in the original bracket.
( See Fig. 10-a.)
C. Install the supplied 8mm stud with a .70” spacer in
the rear most hole.
D. Relocate the ground strap (minus bracket). The
ground strap may be refastened to the transmission
with one of the bracket bolts just removed if the hole
in the ground wire lug end terminal is opened up.
E. Remove the plastic drain fitting cap and install the
supplied 1/2” oil drain hose onto the barb fitting on
the bottom of the supercharger and secure with the
supplied #8 hose clamp.
10. SUPERCHARGER INSTALLATION
7
9. MAIN bRACKET INSTALLATION
A. Lower the supplied cast aluminum mounting bracket
assembly in front of the engine and push tightly
against the exhaust manifold. Lower the power
steering pump between the mounting bracket and
the vehicle frame.
B. Install the two shortest factory power steering bracket
bolts and the two supplied 10mm bolts in each of
the four mounting holes in the supplied mounting
bracket. Tighten to 33 ft/lbs (44 N-m). If necessary,
the A/C bracket can be lowered for bolt access.
C. Loosely install the power steering pump using the
original bolts and tensioner screw.
D. Install the supplied 2.25” idler pulley to the mount-
ing bracket. Make sure that the spacer between the
two idler pulley bearings slides over the mounting
bracket pilot, secure using the supplied 5/16 x 1- 1/4”
bolt and 5/16 washer (see Fig. 9-a).
Fig. 9-a
Fig. 9-b
NOTE: The lower radiator hose should be routed on
the engine side of the mounting plate.
Fig. 10-a