Vortech 1986-1993 Ford 5.0L Mustang - Manual (Page 11)

5.
Idle Bypass Solenoid Relocation and Wire Extension
A. Using the original 6mm bolts and gasket, install
the cast aluminum Vortech idle air adapter in
the position previously occupied by the factory
idle air controller on the throttle body. The
5/8” fitting must be pointing downward.
B. From the 5/8” barbed fitting, temporarily route
the 5/8” x 15” hose to the rear of the passenger
shock tower and position out of the way.
C. The idle air controller plug harness must be
extended to accommodate relocation onto the
aftercooler. Carefully remove approximately
6” of the factory wire wrap.
D. Extend the connector by cutting the wires and
soldering on the matching 12” extensions.
Use the supplied shrink tubing to protect the
soldering joints. Slip the tubing over wire
before soldering and gently heat until tube
seals joint.
6
© 1997, 2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
24JAN00 V 1.0