Vortech 1986-1993 Ford 5.0L Mustang - Manual (Page 6)

1. Preparation and Removal
A. Disconnect and remove the battery (if located
in the factory position).
B. Remove the supercharger discharge tube and
bypass valve assembly.
C. Remove and set aside the supercharger inlet
elbow and flex tube.
D. Remove the belt tensioner, the supercharger
drive belt and supercharger. Set aside.
E. Remove the FMU, disconnect the lines noting
their position for assembly.
F. Remove the idle air control unit and throttle
body linkage from the intake manifold.
G. Remove the upper intake manifold and both
valve covers.
H. Remove the front bumper cover and headlight
assembly (optional).
1
NOTE: Temporarily cap oil feed and oil drain
to protect your engine from foreign particles.
NOTE: The stock valve cover gaskets may
have small metal spacers that could become
dislodged from the gasket during removal.
Check carefully to ensure that they are all
accounted for.
NOTE: Removal of the bumper cover is not
required but will allow easier installation of
the water cooler/pump assembly.
© 1997, 2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
24JAN00 V 1.0