Weston #5 Deluxe Electric Meat Grinder - Manual (Page 10)

-10- -11-
SHREDDER/SLICER ASSEMBLY
Not included with all grinders.
NOTE: The Shredder/Slicer Attachment cannot be used with meat products.
1. Loosen the Head Locking Knob on the side of the Motor Unit.
2. Install the Shredder/Slicer Head onto the Motor Unit (figure 5).
3. Tighten the Head Locking Knob to secure the Shredder/Slicer Head in place.
4. Insert a Blade into the Shredder/Slicer Head until it is fully seated. The open end
of the Blade should face outward. Make sure the notches in the Blade mesh with the
splines on the drive shaft within the cavity of the Head.
5. Insert the Blade Retaining Pin into the hole in the front, upper-right corner of the
Shredder/Slicer Head. The longer leg of the Retaining Pin goes on the inside of the
Blade.
Figure 5
Shredder/Slicer
Stomper
Blade
Shredder/
Slicer Head
Blade
Retaining
Pin
Motor
Unit
Head
Locking
Knob
NOTE: The Shredder/Slicer Attachment cannot
be used with meat products.
NOTE: Follow the “Food Safety Guidelines” in this
manual and as outlined by the U.S. Food and Drug
Administration (FDA) whenever using this appliance.
Keep meat/food refrigerated and covered. Do not
let meat/food sit out any longer than is necessary for
processing.
1. Cut cheese, fruit or vegetables into pieces that
will easily fit into the Shredder/Slicer’s feed chute.
IMPORTANT: Remove pits, stems, shells
and seeds before placing fruits or nuts into the
Shredder/Slicer to avoid damaging the Blade.
2. Place a bowl or plate under the open end of the Shredder/Slicer Head to collect
food as it exits.
3. Make sure the Motor Unit is turned “off.” Connect the Motor Unit to an electrical outlet.
4. Turn the Motor Unit “on.”
5. Feed food into the Shredder/Slicer Head.
6. Use the Stomper to push food into the Shredder/Slicer Head. NEVER use
your fingers! NEVER reach into the Blade opening!
HELPFUL HINT: If the Blade fills with food, turn the Motor Unit “off” and disconnect
it from the electrical outlet. Use a rubber spatula or a wooden spoon to scoop food
out of the Blade into the bowl. NEVER use your fingers! NEVER reach into the
Blade opening!
USING THE SHREDDER/SLICER
Not included with all grinders.
WARNING! Before cleaning, assembling or disassembling the Grinder, make sure
it is turned “off” and disconnected from the power source. Test to make sure there is
no power to the Grinder by switching the Motor Unit “on” and “off.”
Follow all of the Safety Rules
and Warnings in this manual
whenever using this appliance.
Never leave this
appliance unattended.
Disconnect from power supply
when not in use.
WARNING!
Keep fingers, hands,
other body parts and
foreign objects away
from the inlet during
operation!
Only use the provided
stomper to push food into
the appliance.
Keep children away!