Woodhaven 6000: Horizontal Router Table - Manual (Page 3)

4
5
6
7
2
9
8
ATTACH DUST CHUTES
Get the set of Dust Channels (6000F) and insert two
3/4" screws (MF010) thru the part with the countersunk
holes and two 3/4" screws (5771B) thru the remaining
part, then start an oval nut (5760B - flat side first) on the
ends of the screws. Attach a 1-7/8" Double Track (4002)
to each oval nuts and loosely tighten for now. See fig. 5.
Slide the non-cutout Dust Channel/tracks on to the
inner most oval nuts on the sides and tighten the bolts, then
loosen and retighten the screws holding the channel. Repeat
for the other Dust Channel w/cutout/tracks. See fig. 6 & 7.
ATTACH TABLE & FENCE BRACKETS
Install eight 1-1/4" screws (MF020) thru the countersunk
holes in the phenolic table (6000T) and start an oval nut (5760B
- smooth side first) on the ends of the screws. The four screws/
oval nuts in the main field of the table are used to attach the
table to the 9-1/4" tracks. Slide the table/four oval nuts onto
the tracks, position the table so its approximately 1/32" from
the face of the router plate and tighten the screws. See fig. 8.
From each side of the table, slide a 4" double track
(4004) onto two oval nuts on the underside of the table so
the T-slot in the edge of the track faces towards the edge
of the phenolic table and hangs past it slightly. Center the
track on the oval nuts and tighten the screws. See fig. 9.
Insert a 3/4" screw (5771B) thru the holes in the phenolic
fences (6000D) and start an oval nut (5760B - smooth side first)
on the ends of the screws. Slide the oval nuts/fences onto each
4" double track, position the end of the fence 1/32" from the
edge of the plate, then tighten the screws. Using a straight edge,
loosen the screws holding the 4" double tracks on the phenolic
table and adjust the fence faces so they’re in line with the face
of the router plate, then re-tighten the screws. See fig. 9.
4004 Track &
6000D Fence
4002 Tracks
& 6000F Dust
Channels
Dust Channel w/
cutout mounts closest
to router plate.