Woodhaven 1461-1463: Mini Angle Ease - Manual (Page 3)

2
Install a washer (WB002) and a 5/8" spacer (BUSH004)
on the knobs (5864). Using the side/arm assembly with the
height adjuster arm attached to it, set the arm in the groove
in the router block. Install the ratchet handle thru the slot in
the arm, screwing it into the barrel nut. Slide the router block
as far down on the arm as possible (away from the height
adjuster arm) and tighten the knob. Flip the assembly over
and connect the remaining side/arm assembly to the opposite
side of the router block in the same manner. See fig. 5 & 6.
ATTACH ASSEMBLY TO PLATE
Insert 3/4" screws (MF010) thru the four countersunk
holes on (two either side of the bit opening) in the router plate
(1460P1) and start oval nuts (5760B - flat side first) on the
ends of the screws. Line the oval nuts up with the T-slot in
the double tracks and slide the assembly on to the oval nuts.
Position the assembly so the back edge (45º side) of
the sides are 7/8" from the edge of the plate and tighten
the screws. The opening in the router block should be
over the bit opening in the router plate. See fig. 7.
INSTALL HEIGHT ADJUSTER
Install a barrel nut (5791B) in the hole in the front of
the router block. Use a flat blade screwdriver to align the
threaded hole in the barrel nut with the cross hole in the
router block. Get the 1465 Height Adjuster package. Spread
the two nylon washers on the threaded rod of the height
adjuster (1465B) apart enough so the rod slips in the groove
in the adjuster arm (installed earlier) and the washers are on
each side of it. Continue screwing the threaded rod into the
barrel nut until the nylon washer on the top of the adjuster
arm is snug against the top of the adjuster arm. See fig. 8.
Place the arm plate (1465A2) with it’s groove covering
the threaded rod and fasten it to the adjuster arm using
two 3/4" screws (5771B). Align the top and bottom edge
of both parts before tightening the screws. See fig. 9.
Adjust the two nuts on the threaded rod, along with
the washers, against the underside of the adjuster arm.
Tighten the nuts against each other when you have adjusted
the up/down slop out of the height adjuster. See fig. 9.
6
7
8
9