Woodhaven 966: Biscuit Master User Manual
Page 4
7. 45º MITERS
Fasten the Clamp Fence to the center slot as
shown. This setup allows you to do both miters without
repositioning the Clamp Fence for each side. See fig. 7.
8. BEVELS
Remove the Toggle Clamp from the Clamp Fence. Attach
the 6" Fence (4006) to the Clamp Fence using two 1" screws
(MF015) and oval nuts (5760B). The back of the part will rest
against the top edge of this fence. Adjust the Clamp Fence
forward or back until the beveled edge is square to the Base
and flush against the Fences. Hold the part in this position as
you make the cut. The biscuit machine must be raised above
the Base to position the biscuit in the wider part of the bevel.
A typical bevel on 3/4" thick stock will require roughly a 1/2"
thick spacer under the biscuit machine. Because the Fences
are 3/4" tall, the biscuit machine will still be adequately
held between them. Thicker stock would require raising the
biscuit machine even higher. In those cases you can use the
T-slot in the top of the Fences to add spacers. See fig. 8.
9. OPTIONAL ACCESSORIES
We offer longer lengths of Double Track Fence (24"
- PN 4024, or 48" - PN 4048) that replace the stock 6" Fence
on one or both sides of the Biscuit Master. We also offer Flip
Stops which attach to the top of the fence and allow you to use
multiple stops for multiple parts with the same biscuit slots. For
long stock that extends past the MDF Base, you may need to
provide a 3/4" thick spacer for the stock to rest on. See fig. 9.
©Copyright WOODHAVEN INC. 10/16/06
(800) 344-6657 or WWW.WOODHAVEN.COM
3
7
8
9