Woodhaven 7285: Bandsaw Fence Circle Jig - Manual (Page 3)

2
5
Center and fasten the 15-5/8" One Track
(7285E) in the groove of the Circle Jig Base (7285D)
using the 7/16" screws (SFP011). See fig. 5.
Place the nylon washer (WN003) on the pivot screw. See
fig. 6. The Circle Jig Base has a bronze bushing installed in
a hole at one end of the base. Install the Circle Jig Base on
the pivot screw so it pivots on this bushing. The Circle Jig
Base does not fasten to the pivot screw. The Circle Jig Base
should just clear the blade. If not, adjust the position of the
pivot screw in relation to the blade and test again. See fig. 6.
Install the 1" screw (MF015) thru the countersunk
hole of the miter lock (4959C). Install the 3/8" spacer
(BUSH050) and nut (NUT015) on the screw and set the
miter lock in the miter slot of your band saw. See fig. 7.
Pivot the Circle Jig Base until the center of the One
Track is in line with the front of the band saw blade.
Slide the spacer of the miter lock against the back edge
of the Circle Jig Base and tighten the nut. See fig. 7.
Start the 1/4" Set Screw (MA003) in the smooth
side of the Circle Pin (7285C) and slide the Circle
Pin in the T-slot of the One Track. See fig. 5.
6
7