Woodhaven 4951: Large Cut-Off Sled - Manual

Miter Bar being installed
on MDF Base. Bar
will be fl ush with
edge of base.
BEFORE BEGINNING
Identify and verify that
you have all the parts listed
and read thru the instructions
at least once before beginning.
All set-up work should be done
with the saw disconnected from
the power and the saw blade
lowered below the table. This unit is designed for table saws with
at least a 27" deep table. Do not attempt to use on table saws with
smaller tables. If necessary, add additional supports to your saw
to prevent the saw from tipping. This unit relies on the miter slot
of your saw being parallel to the saw blade for it to work properly.
If this is not the case, make those adjustments to your saw first.
MOUNT THE MITER BARS TO THE MDF BASE
Prepare the Miter Bars according to the instructions
that come with them, using the hardware included.
The Cut-Off Sled can be used with the miter bars in
either miter slot. We suggest you mount it in the miter slot you
normally use your miter gauge in. Place the miter bars (4918B)
with the countersunk holes facing down, in the miter slot. There
are mounting holes for the miter bars in one of the MDF bases
(4951D). Align the mounting holes in the MDF base with the
threaded holes in the bars. Position the base over the bars so
that it overhangs the cutting path of the saw blade by 1/2"
or less. Attach the bars to the base with the 1" screws. The
bars will overhang the base approximately 2" at each end. Re-
check the fit of the bar/base assembly, making sure it slides
smoothly, readjusting the plugs as necessary. See fig. 1.
Parts List:
Please identify and verify that you have all of the
hardware shown below prior to assembly.
Part Description Quantity
4951D MDF Base . . . . . . . . . . . . . . . . . . . . . . . . . 2
4918B 17-3/4" Miter Bar . . . . . . . . . . . . . . . . . . 2
4951E Guard . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
4951B Brace . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
4424 24" Ultra Track . . . . . . . . . . . . . . . . . . . . 2
4412 12" Ultra Track . . . . . . . . . . . . . . . . . . . . 2
4951C 24" Sub-Fence . . . . . . . . . . . . . . . . . . . . . 2
4951S Straight Stop . . . . . . . . . . . . . . . . . . . . . . 1
3724R/L 24" Left & Right Tapes . . . . . . . . . . . . . 1
4951
Large Cut-Off Sled
Please Read Carefully!
Part# Description Qty.
5771B 3/4"
Screw 4
Part# Description Qty.
HB030 1"
Bolt 20
Part# Description Qty.
5760B Oval
Nut 36
Part# Description Qty.
WB002 Washer
20
Part# Description Qty.
MF010 3/4"
Screw 12
1
1
4918B 4951D
4918B