Woodhaven 4963: Taper Master - Manual

4963
Taper Master
Owners Manual
Please Read Carefully!
Part# Description Qty.
WS002 Washer
3
Part# Description Qty.
5760B Oval
Nut 7
Part# Description Qty.
HB030 1"
Bolt 1
Part# Description Qty.
BUSH001 1/8"
Spacer 3
Part# Description Qty.
BUSH002 1/4" Spacer
2
Part# Description Qty.
5590 Knob
1
Part# Description Qty.
BUSH004 5/8" Spacer
1
Additional Hardware:
Parts listed below are not shown in the hardware
drawings. Refer to photos in the instructions:
Part Description Quantity
4963B MDF Base . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
4963A 32” Ultra Track Fence . . . . . . . . . . . . . . . . . . . . . 1
6305IC Inboard Clamp . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
4918B 17-3/4" Jig Bars . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Part# Description Qty.
NUT025 Square
Nut 3
Part# Description Qty.
5505 Thumb
Screw 1
Part# Description Qty.
5864 Ratchet Handle 3
BEFORE BEGINNING
The
4963 Taper Master makes cuts up to 40" long and
can be used in either miter slot of a table saw as long as the
miter slot is between 4" to 7-1/2" from the saw blade. Make
sure the 40" capacity is sufficient and your miter slot locations
are in the range given before proceeding. Identify and verify
that you have all the parts listed. Read the instructions at least
once, familiarizing yourself with the parts, before beginning
assembly. You’ll need a #2 Phillips screwdriver for assembly.
The Taper Master relies on the miter slot of your saw being
parallel to the saw blade for it to work properly. If this is not the
case, make those adjustments to your saw before proceeding.
The 4963 Taper Master may also be used on a band saw.