Woodhaven 8531: 3" Hinge Routing Jig, 5/8 Radius" - Manual

BEFORE BEGINNING
Identify and verify that you have all the parts listed.
Read the instructions at least once before beginning.
ASSEMBLY
Cut a wood fence approximately 3/4" thick, 1-1/4" wide
and 12" long to mount the Hinge Jig to. If you want, you can
make the wood fence longer to mount more then one Hinge Jig
to it so you can cut two or more hinge mortises at a time.
Drill two 1/8" pilot holes in the edge of the wood fence 6-3/8"
on center. Attach the wood fence to the underside of the jig using the
3/16" Washers (WS003) and 3/4" Screws (STP001). See fig. 1, 2 & 3.
Attach the 1/4" Spacers (BUSH002) to the underside
of the jig using the 1/2" Thumb Screws (5503). See fig.
1, 2 & 3. The other two holes in the jig are for storing
the thumb screws & spacers when not needed.
1
Parts List:
Part listed below is not shown in the hardware
drawings. Refer to photos in the instructions:
Part Description Quantity
8531 3" Hinge Jig . . . . . . . . . . . . . . . . . . . . . . . . . . 1
In addition, please identify and verify that you have all of
the parts shown below prior to assembly.
Part# Description Qty.
WS003 1”
Washer 2
Part# Description Qty.
BUSH002 1/4" Spacer
2
Part# Description Qty.
STP001 3/4"
Screw 2
Part# Description Qty.
5503 Thumb
Screw 2
1
3-1/8" opening
8531 Hinge Jig
Attach spacers here
Jig
Spacer
Thumb
Screw
Door
Wood
Fence
2
3
Picture may not be
of your Hinge Jig.
8531
Hinge Jig
Please Read Carefully!