XAIRCRAFT X650 Value - Manual (Page 17)

P3002-A
螺旋桨正桨
Clockwise Blade
P3002-B
螺旋桨反桨
Counter-Clockwise Blade
螺旋桨必须贴紧电机，以保证四个螺旋桨的
高度一致性。
Close
to motor to make
sure 4 blades in the same height.
Motor Blade
用螺
丝刀穿过桨夹上的孔来拧紧桨夹。
We recommend you use the driver to poke through the hole on
the locker for better tighten in case of any loose of the screw
during your flight.
桨夹必须拧紧，以免飞行时脱桨造成危险。建议 螺丝刀
Screw Driver
电路安装完成后，请勿安装螺旋桨，进行X650 Value无桨通电测
试。
1 将遥控器油门收到最小后打开遥控器开关。
2 X650 Value接通电源。
3 轻推油门。
4 观察四个电机启动是否顺畅，旋转方向是否正确。
a) 如果电机没有启动或启动不畅，则将油门收到最小，断开
X650 Value的电源，检查电路和电机后重新测试，直到正
常。
b) 如果旋转方向不正确，则将油门收到最小，断开X650
Value电源，对调任意两条电机线，直到电机旋转方向都正
确。
5 推动各操纵杆，观察电机的转速是否有变化。
6 测试完成，将油门收到最小，断开X650 Value的电源。
无桨通电测试 Power-on Test without Propellers
After electronic parts installation, DO NOT install the
propellers and follow in steps.
1 Lowest the RC throttle then turn on the transmitter.
2 Power on X650 Value.
3 Apply the throttle slowly.
4 Note if four motors rotate smoothly
a) If motor does not rotate or not smoothly enough,
please throttle down to the lowest then unplug X650
Value. Check on electronic circuit and motors to
retest until it works fine.
b) If not in the right direction, lower the throttle to
minimum and power off X650 Value. Swap any motor
wire of three connecting to the holes until it works in
the right way.
5 Poke all control sticks to observe motor rotation speed
changes or not.
6 Throttle back to lowest and power off X650 Value.
15
螺旋桨印有XAircraft标志面朝
上，并确保螺旋桨旋转时方向正
确。
Make sure the XAircraft Logo
side up, and check the
rotation of blades.
螺旋桨安装 Propeller Assembly
P3002-B
螺旋桨反桨
Counter-Clockwise Blade P3002-A
螺旋桨正桨
Clockwise Blade
P3002-B
螺旋桨反桨
Counter-Clockwise Blade P3002-A
螺旋桨正桨
Clockwise Blade
www.xaircraft.com
M1
M3
M2
M4