Toro ECXTRA INDOOR - Manual (Page 34)

The following watering control features enable you to fur-
ther control the watering program during operation.
All watering control features apply to watering programs
started manually and automatically.
To Pause Watering
Press the +/
on
and –/
off
buttons at the same time.
• The zone currently watering will shut off.
• The “Watering On” symbol will begin flashing.
• The display will show the amount of run time
remaining for the paused zone.
Note:
If watering is not resumed within 8 minutes,
all watering operations will be canceled and the
timer will return to the automatic mode.
To Resume Watering (when paused)
Press the
next
button.
• Watering activity will resume from the point of
interruption.
To Cancel Watering
Press the +/
on
and –/
off
buttons at the same time -
two times.
• All watering operations will be canceled and the timer
will return to the automatic mode.
Note:
Placing the control dial in the
off
position for
two seconds, then back to
run
will also cancel all
watering operations.
To Skip Zones
Press the
next
button one time.
• The zone currently watering will shut off and the next
zone will start.
• If the last zone is skipped, the program will end.
If additional programs have been set to operate,
the next program in alphabetical order will start.
To Adjust the Zone Run Time
Press the +/
on
button to increase run time or the –/
off
button to decrease run time.
•
If the zone run time is decreased to less than
1 minute, the zone will shut off. The next zone
in sequence will start.
• The zone run time is changed during this operation
only. The program memory will not be changed.
Watering Control Features