DSC POWERSERIES PC1616 - Manual (Page 14)

10
NOTE:
The Master Code cannot use the Bell Squawk attribute, but is required to enable it for other
codes.
NOTE:
This feature cannot prevent the Arm/Disarming squawks from being generated if an access
code assigned to a WLS Key is manually entered at a keypad.
Partition Assignment Mask
In order to accommodate Access Code Partition Assignment for the multiple partitions found on this
product the user must enter [
✱][5][Master Code][98][Code number to be change] (ex.
[
✱][5][1234][98][Code 03]. Under this section, each bit represents the corresponding partition’s
access (i.e. Bit 4 represents Partition 4 access).
The Master Code has access to all partitions, and cannot be modified.
Partition Assignment Mask ([
✱
][5][Master/Supervisor Code][98][Code])
1. Partition One Access (available for PC1616/PC1832/PC1864)
2. Partition Two Access (available for PC1616/PC1832/PC1864)
3. Partition Three Access (available for PC1832/PC1864)
4. Partition Four Access (available for PC1832/PC1864)
5. Partition Five Access (available for PC1864)
6. Partition Six Access (available for PC1864)
7. Partition Seven Access (available for PC1864)
8. Partition Eight Access (available for PC1864)
Notes on Access Codes and Programming
1. - [
✱][5][MASTER CODE] [01 to 95] to program access codes
- [
✱][5][MASTER CODE][98] enters the Partition Assignment Mode [01 to 39 and 41 to 95] to edit
access code partition assignments
- [
✱][5][MASTER CODE][99] Enters the Attribute Mode to edit access code Attributes.
2. The Master Code’s attributes cannot be changed.
3. When a new code is programmed in it will be checked against all other codes in the sys-
tem. If a duplicate code is found, an error tone is given and the code is returned to what it was
before it was changed. This applies to both 4 and 6-digit codes.
Erasing an Access Code
To erase a code, select the code and enter as the first digit. If is entered, the system will
delete the code immediately and the user will be returned to select another code.
User Function Commands
First disarm the system then enter [Master Code]
The command is used to gain access to the following list of Master functions of the system.
[1] Time and Date
Enter 4 digits for 24 Hour System Time (HH-MM). Valid entries are 00-23 for the hour and 00-59 for
minutes. Enter 6 digits for the Month, Day and Year (MM-DD-YY)
[2] Auto-arm/Disarm Control
Pressing [2] while in the User Function menu will enable (3 beeps) or disable (one long beep) the
Auto-arm and Auto-Disarm feature, by partition. With this feature enabled, the panel will automati-
cally arm in the Away mode (Stay Away zones active) or disarm at the same time each day. The auto-
arm time is programmed with the [
✱][6][Master Code][3] command. Auto-Disarm must be pro-
grammed by the system installer.
[3] Auto-arm Time
The system can be programmed to arm at a programmed time each day, per partition. Upon entry of
this section, enter 4 digits for the 24-hour Auto-arm time for each day of the week.
At the selected auto-arm time, the keypad buzzers will sound for a programmed amount of time
(programmable by the installer only) to warn that an auto-arm is in progress. The bell can also be
programmed to squawk once every 10 seconds during this warning period. When the warning
period is complete, the system will arm with no exit delay and in the Away Mode.