Programming transmitters to the vehicle, Battery replacement – Pontiac 2009 Torrent User Manual

Page 82

Advertising
background image

Press and hold

L

for more than two seconds to activate

the panic alarm. The turn signal lamps flash and the horn
sounds repeatedly for 30 seconds. The alarm turns off
when the ignition is moved to ON/RUN or

L

is pressed

again. The ignition must be in LOCK/OFF for the panic
alarm to work.

The RKE transmitter is used to arm/disarm the content
theft-deterrent system. The theft-deterrent system can
be programmed to three different modes. See Content
Theft-Deterrent
on page 2-17.

If you accidentally set off the alarm when entering or
exiting the vehicle, press

Q

or

K

once or

L

twice

to turn it off.

Programming Transmitters to the
Vehicle

Only RKE transmitters programmed to the vehicle will
work. If a transmitter is lost or stolen, a replacement
can be purchased and programmed through your
dealer/retailer. When the replacement transmitter is
programmed to the vehicle, all remaining transmitters
must also be programmed. Any lost or stolen transmitters
no longer work once the new transmitter is programmed.
Each vehicle can have up to four transmitters
programmed to it. See “Learn Remote Key” under
DIC Operation and Displays on page 3-42.

Battery Replacement

Notice: When replacing the battery, do not touch
any of the circuitry on the transmitter. Static
from your body could damage the transmitter.

To replace the battery:

1. Separate the transmitter with a flat, thin object

inserted into the notch on the side.

2. Remove the old battery. Do not use a metal object.

3. Insert the new battery, positive side facing down.

Replace with a CR2032 or equivalent battery.

4. Snap the transmitter back together.

2-6

Advertising