Dimplex DF3015 - Manual (Page 12)

To access the lower light bulb area:
NOTE
Figure 7
1. Slide fireplace out of mantel 2-3 inches.
2. Remove 4 Phillips screws from the right side
of
trim.
3. Slide glass to right side of fireplace to remove.
4. Pull the front edge of the plastic ember bed or
plastic grate up and forward until the rear tab
releases from the ledge located at the bottom
of the mirror.
IMPORTANT
Only handle the logset by the
emberbed.
NOTE
Logset fits tightly into firebox, some
force may be necessary to remove.
5. Set logset in front of fireplace.
6. Disconnect the logset LED wire harness
from unit.
7. Unscrew bulbs counter clockwise.
8. Insert new bulbs.
9. Reconnect the logset LED wire harness.
10. Replace the logset by inserting the front edge of the
fireplace and push down on the rear edge of the
emberbed until it snaps into place. (Figure 8)
NOTE
Ensure the logset is installed tightly under the
back ledge to prevent light leakage.
11. Slide front glass back into position and attach trim.
UPPER LIGHT BULB REQUIREMENTS
Quantity of 2 clear chandelier or candelabra bulbs with an E-12 (small) socket base, 25 watt
rating.
DO NOT EXCEED 25 WATTS PER BULB
To access the upper light bulb area:
Figure 7
1. Slide fireplace out of mantel 2-3 inches.
2. Remove 4 Phillips screws from right side
of trim.
3. Remove trim.
4. Slide glass to the right side of the fireplace
to remove.
5. Remove upper light panel.
6. Upper bulbs located in the upper left and upper
right corners of fireplace.
7. Unscrew bulbs counter clockwise.
Insert
new bulbs.
8. Re-install upper light bracket.
Slide front glass back into position and attach trim.
Lower
Bulbs
Upper
Bulbs
Logset
Front
Glass
FIGURE 7
FIGURE 8
LED Wire
Harness Trim
10
Upper Light
Pannel