Pilz PNOZ m1p base unit - Manual (Page 3)

Content
Operating Manual PNOZ m1p (ETH)
20878-EN-12
3
Section 1 Introduction 5
1.1 Validity of documentation 5
1.2 Retaining the documentation 5
1.3 Definition of symbols 5
Section 2 Overview 6
2.1 Range 6
2.2 Unit features 6
2.3 Chip card 7
2.4 Front view 7
Section 3 Safety 10
3.1 Intended use 10
3.2 System requirements 10
3.3 Safety regulations 10
3.3.1 Use of qualified personnel 10
3.3.2 Warranty and liability 11
3.3.3 Disposal 11
3.3.4 For your safety 11
Section 4 Function description 12
4.1 Integrated protection mechanisms 12
4.2 Functions 12
4.3 Block diagram 12
4.4 Diagnostics 13
4.5 Cascading 13
4.6 Safety mat, muting 13
4.7 Interfaces 13
Section 5 Installation 14
5.1 General installation guidelines 14
5.2 Dimensions 15
5.3 Install base unit without expansion module 15
5.4 Connecting the base unit and expansion modules 15
Section 6 Commissioning 17
6.1 Wiring 17
6.2 Ethernet interfaces (only PNOZ m1p ETH) 18
6.2.1 RJ45 interfaces ("Ethernet") 18
6.2.2 Requirements of the connection cable and connector 18
6.2.3 Interface configuration 18
6.2.4 RJ45 connection cable 19
6.2.5 Process data exchange 20
6.3 Preparing for operation 20
6.3.1 Function test during commissioning 20
6.3.2 Commissioning the PNOZmulti control system for the first time 21
6.3.2.1 Load project from chip card 21