Nexen DPC-11T 961200 - Manual (Page 13)

10 FORM NO. L-20070-F-1209
BEARING PARTS REPLACEMENT (continued)
REFER TO FIGURE 9.
6. Remove Retaining Ring (Item 17).
7. Fully supporting the Housing (Item 5); press the Hub
(Item 1), out of the Housing and Bearings.
8. Remove Retaining Ring (Item 18).
9. Fully supporting the Housing (Item 5); push the
Bearing (Item 16), and Spacer (Item 17), out of the
Housing.
10. Clean bearing contact surfaces of both Housing
(Item 5), and Hub (Item 1) with fresh safety solvent.
11. Press new Bearings (Item 16), and Spacer (Item 7
into the Housing (Item 5).
NOTE
When installing new Bearings; carefully align
the Bearing O.D. with the Housing bore. Apply
Loctite ® RC 601 or equivalent to the outer race
of the new Bearings.
12. Install Retaining Ring (Item 18).
13. Fully supporting the inner race of the new Bearings;
press the Hub (Item 1) into the Bearings, and
Housing.
14. Install Retaining Ring (Item 17).
15. Reverse Steps 1 through 5 to reassemble the DPC
Clutch. Be sure to note the chalk alignment marks
and tighten all screws to the recommended torque
(See Table 4).
CAUTION
Working with spring loaded or tension
loaded fasteners and devices can cause
injury. Wear safety glasses and take the
appropriate safety precautions.